Surface preparation is usually 40 to 60 per cent of the labour on an exterior repaint, and it is the single largest factor in how long the finish lasts. A properly prepared coastal exterior gives you five to seven years. The same paint over an unwashed, unsanded, unprimed surface can start failing inside two. Preparation is also the easiest thing to leave out of a quote, which is why the best painters name every step in writing.
You cannot inspect preparation after the topcoat goes on. That is exactly why it gets skipped.
The full sequence
- Wash. Soft washing removes salt, dirt, mould and lichen. A full house runs $260 to $735. On the coast this step is not optional.
- Scrape and sand. Remove loose and flaking material, feather the edges so repairs do not telegraph through.
- Repair. Cut out rotted timber, replace board ends, treat rust on fixings, rake and patch cracked render.
- Fill and gap seal. Filler in holes and splits, flexible sealant at joints and around frames where water gets in.
- Prime. Spot prime bare areas, full prime chalking or unstable surfaces, use the correct primer for the substrate.
- Protect. Mask, drop sheet, cover plants, tapware and paving.
Only then does the first topcoat go on. Skipping any step in that list does not save a proportional amount of money, it removes a disproportionate amount of life from the finish. The best painters treat the sequence as non-negotiable.
What each substrate needs
- Weatherboard: the most preparation of any residential substrate, which is why it runs $45 to $80 per square metre. End grain, board laps, rot at the base and around downpipes.
- Render: crack repair, checking for previous coating compatibility, and a binding primer where the surface is chalking. Typically $30 to $55 per square metre.
- Brick and bagged surfaces: efflorescence and moisture testing before anything else.
- Interior plaster: patching, sanding, sealing new work. Interior rates run $20 to $60 per square metre.
- Timber decks: clean and dry before oiling at $25 to $45 per square metre, or strip and sand at $45 to $80 for a full restoration.
Why the coast raises the stakes
Salt sits on every exterior surface within a few kilometres of the water. Paint over it and you have sealed a hygroscopic layer under the film, where it will keep pulling moisture in and pushing the coating off. Nothing else you do to the job matters as much as removing it first.
Southern Peninsula housing stock makes this worse. In Rye, Sorrento, Blairgowrie and Portsea, well over 90 per cent of dwellings are detached houses, overwhelmingly timber or fibro. Timber moves, and it needs the preparation that weatherboard painting demands rather than the light sand that a rendered wall might get away with.
How to check it was actually done
You do not need to be a tradesperson to verify preparation:
- Was there a wash day before any painting started?
- Are there sanding dust and scrapings in the drop sheets?
- Can you see patches of primer on the bare areas before the topcoat?
- Have rotted board ends been replaced rather than filled?
- Are gaps around window frames sealed, not just painted across?
- Did anyone stop work when it rained or the dew came in?
Ask for photographs at the preparation stage. Any painter proud of their prep will be happy to send them, and for an owner who is not on site those photographs are the whole quality record. That is why staged photographic reporting is built into our holiday home painting service.
Paying for the invisible half
When you compare quotes, the one with the longer preparation list is usually the better value even at a higher price, because preparation is what you are actually buying from the best painters. Paint is the part you can see. Everything that makes it last happened before it went on.
To get a quote that names each preparation step for your substrate, request an instant painting quote and book a site inspection, which is the only way to price the repairs accurately.
Frequently Asked Questions
How important is surface preparation before painting?
It is the most important part of the job. Preparation typically accounts for 40 to 60 per cent of the labour on an exterior repaint and determines whether the finish lasts two years or seven. The same paint applied over a washed, sanded and primed surface performs completely differently to paint applied over salt and chalk.
What does proper preparation involve?
Washing or soft washing, scraping and sanding back loose material, repairing rotted timber and rusted fixings, filling and gap sealing, then priming bare or unstable areas with the correct primer for the substrate. Protection of plants, paving and tapware comes last before the first topcoat is applied.
Do I need my house washed before painting?
On the Mornington Peninsula coast, yes. Airborne salt is hygroscopic, so painting over it traps a layer that keeps drawing moisture into the film and pushing the coating off from beneath. Soft washing a full house costs $260 to $735 and is among the cheapest insurance you can buy on a repaint.
How can I tell if a painter skipped the prep?
Look for a wash day before painting, sanding dust and scrapings in the drop sheets, visible primer patches on bare areas, replaced rather than filled rot, and sealed gaps around window frames. Ask for photographs at the preparation stage. Painters who take prep seriously are glad to be asked about it.